New from Audiolab – the DC Block!

OVERVIEW

The typical mains supply is subject to various kinds of interference and non-linear loads, which distorts the AC waveform. Asymmetrical loads will cause the waveform to be offset and result in what is known as ‘DC on the mains’. The amount of DC is only small, typically less than 500mV, but it only takes a small amount of DC to saturate a modern high flux toroidal transformer. Saturation of the transformer will invariably result in reduced efficiency and mechanical vibration.

Removing the DC from your mains supply will not only restore efficiency and reduce mechanical hum of noisy transformers, it will also improve the performance of the connected audio equipment, resulting in greater clarity and dynamics.

The Audiolab DC BLOCK utilises a simple connection and intelligent design that will help remove DC from your mains power supply, instantly.

As well as DC removal, the Audiolab DC BLOCK provides additional mains conditioning and RF filtering, of both common and differential mode noise, which further contributes to the optimal operation of your audio equipment.

The Audiolab DC BLOCK mains conditioner is compatible with most audio equipment that utilises an IEC mains inlet and will offer a no-nonsense, instant improvement to the mains power supply, and ultimately, the performance of your Hi-Fi system.

KEY FEATURES

Removes DC from AC mains supply
Reduces transformer hum
Reduces RF interference
Improves the performance of audio components
Available in Black or Silver

SPECIFICATION

Power Requirement: 100-240V ~ 50-60Hz
Peak Load*: 600VA
Audio Power Amplifier Compatibility: < 2 x 150w or < 1 x 300w
Dimensions (WxHxD): 113 x 59 140 (mm)
Weight (net): 0.7kg

* Note: The Audiolab DC BLOCK is designed for audio equipment with
variable power requirements up to max. Peak Load and should not feed
any permanent high power loads such as heaters or similar.

RRP: £99.95